Stainless Steel Machinery Parts Manufacturer takes you to understand things that will produce when making mechanical parts

Release time:

2023-01-11

1. Welding arc marks. Stainless Steel Machinery Parts manufacturers tell you that when welders strike arcs on metal surfaces, they can cause surface roughness defects. The protective film is damaged, leaving a potential source of corrosion. The welder should strike the arc on the bead that has been welded or on the side of the weld joint. The arc strike is then fused into the weld.

Stainless Steel Machinery Parts Manufacturer takes you to understand things that will produce when making mechanical parts

2. Welding spatter. Weld spatter has a lot to do with the welding process. For example, GTAM (Gas Tungsten Arc Welding) or TIG (Inert Gas Tungsten Arc Welding) no spatter. However, GMAW (Gas Metal Arc Welding) and FCAW (Flux Core Arc Welding) welding processes can cause a lot of spatter if the welding parameters are not used properly.
Stainless Steel Machinery Parts manufacturers tell you that when this happens, the parameters must be adjusted. If you want to solve the problem of welding a spatter, you should apply a spatter inhibitor on each side of the joint before welding, which can eliminate the adhesion of the spatter. After welding, this anti-splash agent and various spatters can be easily removed without damaging the surface or causing minor damage.
The above information is the Stainless Steel Machinery Parts manufacturer's introduction and analysis of the things that will produce when making mechanical parts, hope it helps you.